Logo

C2328 Engine Trouble Code

Meaning of C2328 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C2328 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for C2328 code is occuring now you should check C2328 repair processes.
Now don't ask yourself; What should you do with C2328 code ?
The solution is here :

C2328 Possible Solution:

C2328 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

C2328 Code Meaning :

C 2 3 2 8
OBD-II Diagnostic Chassis (C) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Throttle/Pedal Position Sensor/Switch A Circuit Intermittent Turbocharger Boost Sensor A Circuit Low Clutch Position Sensor Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C2328 OBD-II Diagnostic Chassis (C) Trouble Code Description

C2328 engine trouble code is about Clutch Position Sensor Circuit Malfunction.

Main reason For C2328 Code

The reason of C2328 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

C2328 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.